Comprehensive guide for operating automatic paper tube making machine
1、 General operating procedures
Power on preparation
Check the status of the power supply (380V three-phase four wire), gas source (0.5-0.6MPa), and equipment fasteners.
Run without load for 1-2 minutes to confirm that there are no abnormal noises or vibrations.
Parameter settings
Input the paper tube length, cutting width, and speed (adjustable from 3-18 meters/minute) through the PLC touch screen.
Adjust the angle of the scroll or replace the scroll to meet different diameter requirements (18-200mm).
Production operation
After fixing the paper tube, start automatic winding and pay attention to tension control and uniformity of adhesive coating.
Maintain vertical force during cutting to avoid uneven cutting caused by offset.
2、 Safety regulations for automatic paper core making machine
Protective equipment: Operators need to wear goggles, cut resistant gloves, and tie up long hair.
Exception handling: In case of abnormal noise or material jamming, immediately stop the machine, cut off the power, and troubleshoot.
3、 Maintenance points of the kraft paper tube making machine
Daily maintenance: Regularly clean the rubber pot and lubricate the transmission components (such as the hundred needle mechanism).
Tool maintenance: Check the wear of round knives, and replace high carbon steel tools regularly.
4、 Model differences
CNC pipe cutting machine: supports automatic positioning, material head cutting, and capacity counting functions.
Manual pipe cutting machine: The cutting blade position needs to be manually adjusted, and cutting at a height exceeding 125mm is prohibited.
Note: Specific operations should refer to the equipment manual. It is recommended to undergo training before starting work.
If you are also interested in this machine,please don’t hesitate to contact us:
Overseas manager: Tom Wang
Email:cartonmachine.tomwang@aliyun.com
Phone/Wechat/Whatsapp:+86 13303078975
Post time: Sep-30-2025